Photos
Description
T-molds are often referred
to as "t-strips". T-molds are used to
transition between two floorcoverings of equal height.
Often these transitions are used between two rooms where the
same floorcovering is installed. The t-mold can also
be used to transition wood to tile floor covering. As with
the threshold, the t-mold is an overlapping profile supported in
the center by a leg. The t-mold is designed to have a low
profile for easier cleaning and reduced trip hazards.
Specs at a Glance
Dimensions
Species
-
Red Oak
-
White Oak
-
Maple
-
African
Mahogany
-
Brazilian
Cherry
-
Others by
special order
Stain
Finish
-
Machine finished in our facility
-
The finish has added UV inhibitors to reduce the
effects of ambering.
-
Moulding Solutions uses only environmentally friendly, VOC
compliant finishes. Our high solids, high build finishes are
machine applied and quick cured through various methods
including chemical reaction and energy based methods. The
result is an even coat along the entire length of the
product. Our finishes have an added UV absorber to prolong
the life of the finish and resist ambering, or
"yellowing"
of the product from age. The resulting product will last
for years to come.
Installation
-
Proper
installation is detailed in the image at the
top of this page
-
The t-mold must
be installed so the flat sections on the rear underside of
the piece are resting squarely on top the floorcovering and
the bottom "leg" is resting on the sub-floor
-
Use shims as
necessary to provide extra support
Download CAD Sheet
CAD sheets are a 1:1 drawing in
Adobe .PDF format that allows you to view and print each
profile. This can be especially useful when comparing
different product profiles or determining product
suitability for a particular application.
|
